Sulfur Vapor-Infiltrated 3D Carbon Nanotube Foam for Binder-Free High Areal Capacity Lithium-Sulfur Battery Composite Cathodes

Here, we demonstrate a strategy to produce high areal loading and areal capacity sulfur cathodes by using vapor-phase infiltration of low-density carbon nanotube (CNT) foams preformed by solution processing and freeze-drying. Vapor-phase capillary infiltration of sulfur into preformed and binder-free low-density CNT foams leads to a mass loading of ∼79 wt % arising from interior filling and coating of CNTs with sulfur while preserving conductive CNT-CNT junctions that sustain electrical accessibility through the thick foam. Sulfur cathodes are then produced by mechanically compressing these foams into dense composites (ρ > 0.2 g/cm³), revealing specific capacity of 1039 mAh/g_S at 0.1 C, high sulfur areal loading of 19.1 mg/cm², and high areal capacity of 19.3 mAh/cm². This work highlights a technique broadly adaptable to a diverse group of nanostructured building blocks where preformed low-density materials can be vapor infiltrated with sulfur, mechanically compressed, and exhibit simultaneous high areal and gravimetric storage properties. This provides a route for scalable, low-cost, and high-energy density sulfur cathodes based on conventional solid electrode processing routes.