Abstract
Directed energy deposition (DED) is an additive manufacturing (AM) process based on welding technology and offers the advantages of large build volume, high deposition rate, and ability to fabricate multi-material parts. Epitaxial continuous columnar grain growth is a characteristic microstructural feature of DED processed alloys. In this study, a bamboo-like microstructure (periodic alternation of equiaxed and columnar structure) was produced by adopting an intermittent deposition strategy in 316L stainless steel and Inconel 625. The formation of a bamboo-like alternating microstructure was confirmed through electron backscattered diffraction (EBSD) analysis. Hardness mapping showed that the columnar to equiaxed transition (CET) occurred at the region right below the fusion line. A finite element (FE) model was used to investigate the relationship between the temperature gradient (G) and the solidification rate (R). The FE model showed a low G/R ratio at the region right below the interface promoting the CET. The grain size and material-dependent deformation behaviors are analyzed using digital image correlation (DIC). The lower deformation on the fine-grain regions observed in DIC analysis is attributed to a higher strain hardening rate, which is confirmed through dislocation density analysis on a tensile-interrupted specimen. The periodically alternating grain size coupled with the microstructural changes caused by intermittent deposition strategy result in a better strength-ductility synergy in both single-material and bimetallic specimens.
| Original language | English |
|---|---|
| Pages (from-to) | 6444-6460 |
| Number of pages | 17 |
| Journal | Journal of Materials Research and Technology |
| Volume | 33 |
| DOIs | |
| State | Published - Nov 1 2024 |
Funding
The authors of this paper appreciate the continuous support provided by the Center for Manufacturing Research (CMR) and the Department of Manufacturing and Engineering Technology at Tennessee Technological University. This material is based upon work supported by the National Science Foundation under Grant No. 2015693. The authors would like to thank Dr. Philip Barnett for his assistance with the DIC setup. The authors would like to acknowledge support by the US Department of Energy, Office of Energy Efficiency and Renewable Energy, Advanced Manufacturing Office, under contract DE-AC05-00OR22725 with UT-Battelle, LLC. APT research was supported by the Center for Nanophase Materials Sciences (CNMS), which is a US Department of Energy, Office of Science User Facility at Oak Ridge National Laboratory. This work was supported by the National Research Foundation of Korea (NRF) grant funded by the Korea government (MSIT) (No. RS-2024-00346883). The authors would like to thank James Burns for his assistance in performing APT sample preparation and running the APT experiments.
| Funders | Funder number |
|---|---|
| National Research Foundation of Korea | |
| Department of Manufacturing and Engineering Technology at Tennessee Technological University | |
| Office of Energy Efficiency and Renewable Energy | |
| Oak Ridge National Laboratory | |
| Center for Nanophase Materials Sciences | |
| U.S. Department of Energy | |
| Center for Manufacturing Research | |
| Office of Science | |
| National Science Foundation | 2015693 |
| National Science Foundation | |
| Advanced Manufacturing Office | DE-AC05-00OR22725 |
| Advanced Manufacturing Office | |
| MSIT | RS-2024-00346883 |
Keywords
- Deformation mechanisms
- Directed energy deposition (DED)
- Dislocation density
- Grain morphology
