Abstract
We consider the development of a highly efficient, gridless tetrode as a megawatt-level RF source in the 3 to 10 MHz range for application in mobile ionospheric heaters. Such a heater has potential advantages over the stationary facilities, such as High-Frequency Active Auroral Research Program, found at high latitudes. The considered device operates in class D mode with an annular electron beam allowing realization of high efficiency. The present study, based on numerical simulations using the Particle in Cell code Michelle [Petillo et al., IEEE Trans. Electron Devices Sci. 52, 742 (2005)], examines the optimization of device geometry. In particular, the dependence of efficiency on spacing between electrodes is studied. In addition, the role of secondary electrons emitted at the collector is examined. Both static and time dependent operations are simulated. In the time dependent case, it is found that during the portion of the RF cycle when the beam current is on, secondaries emitted from the collector are driven back into the collector by the incoming primary beam. When the beam is switched off, secondaries can stream back into the tetrode and have a small negative impact on efficiency. We present a design in which the secondary electrons are eventually absorbed at the collector rather than at the cathode or anode.
Original language | English |
---|---|
Article number | 093101 |
Journal | Physics of Plasmas |
Volume | 26 |
Issue number | 9 |
DOIs | |
State | Published - Sep 1 2019 |
Externally published | Yes |
Funding
This work was supported by MURI Grant No. FA95501410019. The simulation results were obtained using PIC-code MICHELLE.
Funders | Funder number |
---|---|
Multidisciplinary University Research Initiative |