In-situ gamma radiation induced attenuation in silica optical fibers heated up to 600 C

David P. Hawn, Christian M. Petrie, Thomas E. Blue, Wolfgang Windl

Research output: Contribution to journalArticlepeer-review

36 Scopus citations

Abstract

In this work, the performance of silica fibers was experimentally studied under continuous gamma irradiation and periodic heating in steps to temperatures up to 600 C. The broadband optical attenuation in 10-meter lengths of three different types (one high-OH, two low-OH types) of multimode silica fibers was continuously monitored in-situ throughout the experiment. All three fiber types survived the experiment both optically and mechanically. Results showed that for the gamma dose rate tested in this experiment (476 Gy per hour), gamma radiation primarily affects wavelengths below ~ 1000 nm. For the low-OH silica optical fibers, gamma radiation has little effect on transmission in the infrared, particularly at 1300 nm and 1550 nm. These two wavelengths are commonly used in existing commercial optical sensing equipment. Thermal effects primarily contributed to the increase in absorption in the infrared region for low-OH silica optical fibers. The large OH concentration in the high-OH fiber results in large intrinsic absorption in the near-infrared, making the high-OH fiber unsuitable for transmission at 1300 nm and 1550 nm. However, the high-OH fiber had lower radiation-induced attenuation in the UV and visible ranges including 850 nm, which is another wavelength that is commonly used for sensing applications. The steady state value for the gamma radiation-induced attenuation in the high-OH fiber at 600 nm (the peak wavelength for the absorption due to non-bridging oxygen hole centers) and the time constant for reaching this steady state value both decreased as temperature was increased in the range of 100-400 C, with almost full annihilation of the radiation-induced defects achieved at 400 C. Time constants were on the order of minutes to hours for the gamma dose rate in this experiment and the high-OH fiber that was tested. In general, radiation-induced attenuation was observed to decrease significantly with increasing temperature, particularly at lower wavelengths where most of the defect centers are located. The conditions under which the measurements were made (in-situ as the temperature was varied) also gives insight into the dynamics of the optical attenuation, which may help provide a better understanding of the fundamental physics of radiation-induced optical attenuation. All of the results generated in this work were processed into movies that are available for download.

Original languageEnglish
Pages (from-to)192-200
Number of pages9
JournalJournal of Non-Crystalline Solids
Volume379
DOIs
StatePublished - 2013
Externally publishedYes

Funding

This research was performed using funding received from the Department of Energy Office of Nuclear Energy's Nuclear Energy University Program ( NEUP 09-346 ). This material is also based upon work supported under a Department of Energy Nuclear Energy University Program Graduate Fellowship.

FundersFunder number
DOE Office of Nuclear Energy
Office of Nuclear EnergyNEUP 09-346

    Keywords

    • Attenuation
    • Fiber
    • Gamma
    • Heated
    • Optical
    • Radiation

    Fingerprint

    Dive into the research topics of 'In-situ gamma radiation induced attenuation in silica optical fibers heated up to 600 C'. Together they form a unique fingerprint.

    Cite this