Electrohydrodynamic velocity and pumping measurements in water and alcohols

Costas Tsouris, Won Tae Shin, Sotira Yiacoumi, David W. DePaoli

Research output: Contribution to journalArticlepeer-review

13 Scopus citations

Abstract

Bubble and particle velocities in water and alcohols, under the influence of an electric field, were investigated in this work. Air bubbles were injected into the liquids through an electrified metal capillary insulated by glass with its tip left exposed. The end of the capillary from which the bubbles were released was conical in shape. Due to an electric field formed between the noninsulated capillary tip and a ground electrode immersed in the solvent, small bubbles were formed and used as tracers for the electrohydrodynamic (EHD) flow field. The pressure inside the capillary was measured for all liquids used in this study. For water, ethanol, and n-propanol, it was found that, at relatively low applied voltage, the pressure increases with voltage, reaches a maximum (pressure breakpoint), and then sharply decreases. This behavior is a result of the competition between the electric force appearing at the interface and the force due to the EHD flow near the capillary tip. The electric force tends to increase the pressure inside the capillary, while the EHD flow tends to decrease this pressure. For isopropanol and butanol, the pressure breakpoint was not observed in the range of voltage applied in the experiments. The EHD flow velocity was measured by using microbubbles and particles as flow tracers. An adaptive phase-Doppler velocimeter was employed to measure the velocity of bubbles, while the velocity of particles was measured by trajectory visualization of fluorescent particles. A discrepancy was observed between the two methods because of the location at which the measurements were made. It was found that average velocities of both bubbles and particles increase linearly with applied voltage. Experiments were also conducted to investigate pumping of water, which is a result of the EHD velocity near the capillary tip. The pumping flow rate was linearly related to the applied voltage and agreed well with EHD velocity measurements obtained from particle trajectories. (C) 2000 Academic Press.

Original languageEnglish
Pages (from-to)335-345
Number of pages11
JournalJournal of Colloid and Interface Science
Volume229
Issue number2
DOIs
StatePublished - Sep 15 2000

Funding

Funding for this research was provided by the Environmental Management Science Program, Office of Environmental Management, and the Division of Chemical Sciences, Office of Basic Energy Sciences, U.S. Department of Energy, under contract DE-AC05-00OR22725 with UT-Battelle, LLC. The authors are also grateful to Merry A. Spurrier for assisting with some of the experiments and Dr. Marsha K. Savage for editing the manuscript. 2Managed by UT-Battelle, LLC, for the U.S. Department of Energy under Contract DE-AC05-00OR22725. The U.S. Government’s right to retain a nonexclusive royalty-free license in and to the copyright covering this paper, for governmental purposes, is acknowledged.

FundersFunder number
Division of Chemical Sciences
Environmental Management Science Program
Office of Basic Energy Sciences
U.S. Department of EnergyDE-AC05-00OR22725
Office of Environmental Management

    Keywords

    • EHD
    • Electroatomization
    • Electrohydrodynamic flow
    • Electrostatic spraying
    • Microbubbles

    Fingerprint

    Dive into the research topics of 'Electrohydrodynamic velocity and pumping measurements in water and alcohols'. Together they form a unique fingerprint.

    Cite this