Abstract
A diesel premixed-charge compression ignition (PCCI) technique was used at low loads at which exhaust temperature makes urea-selective catalytic reduction (SCR) use for nitrogen oxides (NOx) reduction challenging. A fuels matrix to examine the effects of increasing fuel volatility, bio-blendstocks, and cetane number on PCCI was formulated using a near-constant 15% aromatic content. The results showed that PCCI could provide greater than 67% NOx emissions reductions at 1,200 RPM, 3.1 bar indicated mean effective pressure (IMEP), and 2.0 bar IMEP. The filter smoke number (FSN) could also be reduced relative to a conventional diesel combustion (CDC) baseline. The reductions in FSN were more moderate in the order of 40-50%, depending upon the fuel used, IMEP, and combustion phasing (CA50) timing. Hydrocarbon (HC) emissions could be held to a marginally lower level than CDC emissions at some CA50 conditions by using higher-volatility and higher cetane number fuels and could potentially be traded for further NOx reductions. This outcome is important as it points to the possibility of achieving significant NOx reduction while doing no harm in terms of HC emissions. Carbon monoxide (CO) emissions increased in PCCI, but increasing the fuel volatility and cetane number could be helpful in keeping these emissions at a manageable level.
Original language | English |
---|---|
Journal | SAE International Journal of Fuels and Lubricants |
Volume | 16 |
Issue number | 1 |
DOIs | |
State | Published - Oct 14 2022 |
Funding
This research was supported by the Department of Energy’s (DOE’s) Office of Energy Efficiency and Renewable Energy (EERE), Vehicle Technologies Office, and used resources at the National Transportation Research Center, a DOE-EERE User Facility at Oak Ridge National Laboratory. This research was conducted as part of the Co-Optimization of Fuels & Engines (Co-Optima) initiative sponsored by the DOE Office of Energy Efficiency and Renewable Energy (EERE), Bioenergy Technologies and Vehicle Technologies Offices. The authors gratefully acknowledges Kevin Stork and Alicia Lindauer for their support of Co-Optima and the work reported herein. The authors would like to thank Tim Lutz and others at Cummins Engine Company for supplying the engine used for this study and for providing support for the machining of the cylinder head for flush mount pressure transducers. Special thanks to Steve Whitted, Scott Palko, Martin Wissink, Jordan Easter, and Chloe Lerin at Oak Ridge National Laboratory for supporting the design and build of the single-cylinder engine setup used for this study and to Brian Kaul for assistance with ORCAS configuration.
Funders | Funder number |
---|---|
DOE-EERE | |
U.S. Department of Energy | |
Office of Energy Efficiency and Renewable Energy | |
Oak Ridge National Laboratory |
Keywords
- ACI
- Advanced compression ignition
- Diesel
- Fuels
- NOx
- PCCI