Abstract
Traditional building envelopes have passive insulation systems that cannot respond to dynamic changes in the environment. An Active Insulation System (AIS) consists of Active Insulation Materials (AIMs) that dynamically vary the thermal conductivity of the insulation system. Several researchers have evaluated the impact of AIS on building thermal and energy performance by using simulation tools. Up to 70% savings in annual heating and cooling energy and significant reductions in peak demand have been predicted for some climates with wall systems employing AIS. However, materials and assembly development still need a cost-effective product that achieves the required performance. In this study, we present the process of developing an AIS that we will install in a test hut for its performance evaluation. Minimum performance criteria of the AIS system are developed based on R-low/R-high ratio, required time and efficiency to switch states, and cost estimates. The following steps during this study are creating the concept to meet the requirements, predicting the performance via simulations, developing the experimental setup for bench-scale testing, and finally, constructing a full-scale wall assembly and monitoring the performance when exposed to environmental chamber tests. The selected approach uses off-the-shelf products to create an AIS that can switch R-value between 0.98 ft2·°F·h/BTU (0.173 m2·K/W) and 5.81 ft2·°F·h/BTU (1.02 m2·K/W) and have a switching time of less than one minute between R-high and R-low.
Original language | English |
---|---|
Pages (from-to) | 822-832 |
Number of pages | 11 |
Journal | Science and Technology for the Built Environment |
Volume | 30 |
Issue number | 7 |
DOIs | |
State | Published - 2024 |
Funding
This manuscript has been authored in part by UT-Battelle, LLC, under contract DE-AC05-00OR22725 with the US Department of Energy (DOE). The publisher acknowledges the US government license to provide public access under the DOE Public Access Plan ( http://energy.gov/downloads/doe-public-access-plan ). The authors are grateful for the support from Jerald Atchley and Gunnar Johnson during the construction of the prototype.
Funders | Funder number |
---|---|
U.S. Department of Energy |