Abstract
Surface reliefs due to phase transformations in a 56.8Ni-5.6Pt-37.6Al at. pct alloy were characterized in situ using digital holographic imaging during thermal cycling from room temperature up to 405 K (132 °C). The 3D images of the surface revealed that the austenite plates formed during heating are exactly the same for each cycle, which is not the case for the martensite plates formed during cooling. The martensite start temperature was found to vary by up to ~ 20 K from one grain to another within the same specimen. The absence of Ni3Al γ′ precipitates, due to the relatively high Al content, results in the propagation of the martensitic transformation over grains up to a millimeter in size. Bright-field optical imaging showed the formation of large martensite plates in some grains, with cracks perpendicular to these plates, upon cycling. Cracks were also observed at grain boundaries and could be related to the height variations across the grain boundaries.
Original language | English |
---|---|
Pages (from-to) | 5259-5270 |
Number of pages | 12 |
Journal | Metallurgical and Materials Transactions A: Physical Metallurgy and Materials Science |
Volume | 49 |
Issue number | 11 |
DOIs | |
State | Published - Nov 1 2018 |
Funding
The authors wish to acknowledge T. Jordan and A. Passian for assistance with the experimental work and B. Pint, Y. Yamamoto, and M. Brady for reviewing the manuscript. This research was sponsored by the U.S. Department of Energy through the Laboratory Directed Research and Development (Seed) Program at Oak Ridge National Laboratory.