Changes in divertor conditions in response to changing core density with RMPs

A. R. Briesemeister, J. W. Ahn, J. M. Canik, M. E. Fenstermacher, H. Frerichs, C. J. Lasnier, J. D. Lore, A. W. Leonard, M. A. Makowski, A. G. McLean, W. H. Meyer, O. Schmitz, M. W. Shafer, E. A. Unterberg, H. Q. Wang, J. G. Watkins

Research output: Contribution to journalArticlepeer-review

11 Scopus citations

Abstract

The effects of changes in core density on divertor electron temperature, density and heat flux when resonant magnetic perturbations (RMPs) are applied are presented, notably a reduction in RMP induced secondary radial peaks in the electron temperature profile at the target plate is observed when the core density is increased, which is consistent with modeling. RMPs is used here to indicate non-axisymmetric magnetic field perturbations, created using in-vessel control coils, which have at least one but typically many resonances with the rotational transform of the plasma (Evans et al 2006 Phys. Plasmas 13 056121). RMPs are found to alter inter-ELM heat flux to the divertor by modifying the core plasma density. It is shown that applying RMPs reduces the core density and increases the inter-ELM heat flux to both the inner and outer targets. Using gas puffing to return the core density to the pre-RMP levels more than eliminates the increase in inter-ELM heat flux, but a broadening of the heat flux to the outer target remains. These measurements were made at a single toroidal location, but the peak in the heat flux profile was found near the outer strike point where simulations indicate little toroidal variation should exist and tangentially viewing diagnostics showed no evidence of strong asymmetries. In experiments where divertor Thomson scattering measurements were available it is shown that local secondary peaks in the divertor electron temperature profile near the target plate are reduced as the core density is increased, while peaks in the divertor electron density profile near the target are increased. These trends observed in the divertor electron temperature and density are qualitatively reproduced by scanning the upstream density in EMC3-Eirene modeling. Measurements are presented showing that higher densities are needed to induce detachment of the outer strike point in a case where an increase in electron temperature, likely due to a change in MHD activity, is seen after RMPs are applied.

Original languageEnglish
Article number076038
JournalNuclear Fusion
Volume57
Issue number7
DOIs
StatePublished - Jun 7 2017

Keywords

  • RMP
  • SOL
  • divertor

Fingerprint

Dive into the research topics of 'Changes in divertor conditions in response to changing core density with RMPs'. Together they form a unique fingerprint.

Cite this