Assessment of ITER divertor performance during early operation phases

Jae Sun Park, Xavier Bonnin, Richard Pitts

Research output: Contribution to journalArticlepeer-review

32 Scopus citations

Abstract

During the ITER design phase, the focus of ITER boundary plasma modeling activities has been on divertor performance under baseline H-mode, fusion power operation (FPO) conditions. However, early ITER operation will be primarily with hydrogen fuel in L-mode, in the pre-fusion power operation 1 (PFPO-1) phase. Here, the SOLPS-ITER code is used to evaluate divertor performance during this non-active phase. To verify the assumptions used in the existing high power simulation database, gas throughput scans were performed for two types of divertor surface material (beryllium and tungsten) and two gas puff locations (divertor and main chamber). The adoption of beryllium target surfaces simulates the effect of main chamber material erosion and migration and, along with main chamber gas injection, is the current default for the high power database. Depending on the divertor surface material, the atom to molecule ratio of the recycled neutral particles varies. This modifies the momentum and power loss mechanisms arising from plasma-neutral interactions. However, since the effect of atomic and molecular reactions are compensatory, the 'total' power and momentum losses are relatively insensitive to the target surface material. Similarly, the impact of gas puff location on divertor plasma parameters is not significant, though main chamber injection provides an additional ionization source in the upstream scrape-off layer (SOL) and leads to moderate changes in the upstream density and far SOL parameters. However, these effects can be neglected within the available range of the gas puff and pump rates in ITER. Since beryllium and tungsten are materials at both extremes in terms of surface reflection properties, the conclusions may be applicable to other divertor surface materials. An important additional finding of the study is that the insensitivity of upstream density to divertor neutral pressure found in the FPO database is also recovered in these PFPO-1 simulations.

Original languageEnglish
Article number016021
JournalNuclear Fusion
Volume61
Issue number1
DOIs
StatePublished - Jan 2021
Externally publishedYes

Fingerprint

Dive into the research topics of 'Assessment of ITER divertor performance during early operation phases'. Together they form a unique fingerprint.

Cite this