Additive manufacturing of ceramic nanopowder by direct coagulation printing

This work investigates the feasibility of a binderless, extrusion-based additive manufacturing approach to fabricate alumina (Al₂O₃) parts from nanopowder. Traditional manufacture of ceramics with subtractive methods is limited due to their inherent hardness and brittleness, inevitably leading to ceramic parts with less-than-optimal geometries for the specific application. With an additive manufacturing approach, ceramic parts with complex 3D geometries, including overhangs or hollow enclosures, become possible. These complex ceramic parts are highly valuable in heat exchanger, condenser, biomedical implant, chemical reactant vessel, and electrical isolation applications. This research employed direct coagulation of alumina nanopowder slurries with the polyvalent salt tri-ammonium citrate providing the solidification mechanism in an extrusion-based printing process. The viscosity of the slurries was adjusted from ∼35 Pa-s to ∼1000 Pa-s by adjusting pH from ∼9 to ∼4, resulting in a paste that is suitable for extrusion, which retains near-net geometry. It was shown that the direct coagulation approach can be used to create a suspension with tuneable flow characteristics and coagulation rate, and a mechanism describing the process was proposed. The direct coagulation printing (DCP) method is described in detail, including how slurry is extruded, solidified, and printed in complex geometries, and sintered to full density. Parts were printed with a sintered resolution of 450 μm and green densities as high as 65%. After sintering at 1550 °C for up to 2 h, parts were shown to be fully dense (>97%) with an average grain size of ∼2 μm. Mechanical properties were characterized with a comparison to different materials and methods from literature, showing hardness and flexural modulus up to ∼1800 HV and 400 GPa, respectively.